Radiator, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2013 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal While Noting The Following:

NOTE:

If There Are Small Impressions On The Slats. Refer To RADIATOR AND CONDENSER ASSEMBLY .

-- If Removed, Tighten The ATF Line. Refer To OVERVIEW - ATF CIRCUIT .

-- Install The Lock Carrier Cover. Refer To LOCK CARRIER COVER, REMOVING AND INSTALLING .

-- Install The Charge Air Cooler. Refer To CHARGE AIR COOLER, REMOVING AND INSTALLING .

-- Install The Impact Member. Refer To IMPACT MEMBER, REMOVING AND INSTALLING .

-- Connect the coolant hose with the connector on the coolant pipe. Refer To Figure.

NOTE:

Used Coolant Cannot Be Used Again.

-- Fill with coolant. Refer To COOLANT, DRAINING AND FILLING .

-- On Vehicles With ATF Circuit, Check The ATF Level. Refer To ATF LEVEL, CHECKING .