LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> S5 4.2, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1175 (Cooling System [CABB, CABA, CABD, CAEA, CAEB, CDHB, CDNB, CDNC, CDHA, CDZA, CADA, CCUA, CFKA, CPMA, CAED, CPMB] (Coupe)) >> 19 Cooling System >> Coolant Pump/Coolant Thermostat >> Engine Coolant Temperature Sensor -G62-, Removing And Installing >> Removing

Engine Coolant Temperature Sensor -G62-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2013 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

-- Loosen The Hose Clamps -Arrows- And Remove The Air Duct Hose.

Fig 1: Air Intake Hose Components
GWWA21-10302Courtesy of AUDI OF AMERICA, LLC

-- Remove the Throttle Valve Control Module -J338-. Refer To THROTTLE VALVE CONTROL MODULE -J338-, REMOVING AND INSTALLING .

-- Remove The Intake Manifold Support; To Do So, Remove The Nut -2- And Bolt -1-.

Fig 2: Identifying Intake Manifold Support, Nut And Bolt
GWWA19-10457Courtesy of AUDI OF AMERICA, LLC

All Additional Procedures Are Described. Refer To COOLANT PUMP, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals