OVERVIEW - Adaptive Cruise Control Sensor -G550-

Fig 1: Identifying Adaptive Cruise Control Sensor

Courtesy of AUDI OF AMERICA, LLC

1. Cover
2. Clip
   • Always replace the clip if the stud bolt -3- was removed.
   • Installed on vehicles from MY 2012
   • Removing and installing. Refer to DISTANCE REGULATION CONTROL MODULE CLIP, REPLACING, FROM MY 2012 .
3. Stud Bolt
   • If the stud bolt is being removed, then the clip -2- must always be replaced.
   • Observe adjustment dimension when installing. Refer to Figure
4. Bracket
   • For vehicles through MY 2012
   • For RS models and allroad
5. Nut
6. Bolt
   • 8 Nm
7. Bolt
   • 8 Nm
8. Angle Bracket
   • Installed on vehicles from MY 2012
9. Spring Nut
10. Bracket
    • For vehicles from MY 2012
11. Adaptive Cruise Control Sensor -G550-
    • There are different versions. For allocation. Refer to the Parts information..
    • Removing and installing. Refer to Adaptive Cruise Control Sensor -G550-, REMOVING AND INSTALLING .
12. Connector
    • Squeeze both clips to release the connector.