LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> S5 4.2, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 932 (Transmission System (Controls & Housing - Service Information - 7-Speed Dual Clutch - 0CK, 0CJA, 0CLA, 0DN, 0DPA)) >> 34 Controls, Housing >> Transmission, Disassembling And Assembling >> Overview - Transmission >> Overview - Transmission, Fwd Vehicles >> Wheel Set Tightening Sequence (Transmission) And Specifications

Wheel Set Tightening Sequence (Transmission) And Specifications

WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Wheel Set Tightening Sequence (Transmission)
GWWA34-11547Courtesy of AUDI OF AMERICA, LLC

-- Push the centering bracket -A- all the way in.

NOTE:

Bolt -6- Without Centering Bracket.

-- Tighten The Bolts In Two Steps In The Sequence Shown: 

Step Bolts Tightening Specification
1.  -1 to 6- Install by hand evenly until the bolt head contact the transmission housing.
2.  -1 to 6- Tighten one after the other to 15 Nm + 90°
scientia non olet · About LEMON Manuals