Securing On Engine And Transmission Holder

WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Shop Crane :VAS6100
Engine and Gearbox Bracket :VAS6095A
Engine/Gearbox Support Shackle (2 pc.) :10-222A/12
Gearbox Support :T40206 and Gearbox Support - Drilling Template :T40206/3
Retaining Strap :T40155
Lifting Eyebolt :3368

PROCEDURE

-- Assemble the :T40206 as follows:

Courtesy of AUDI OF AMERICA, LLC

The connection area -arrow A- points upward.
The lettering "B" points upward -arrow B-.

-- Place the :T40206/3 on the : T40206 .

Courtesy of AUDI OF AMERICA, LLC

-- Make an additional 12 mm hole -arrow- in the :T40206 .

-- Install the bolts as follows in the holes:

M10x80 in the hole 15
M10x120 in the hole 11
M10x80 in the hole 7
M10x50 in the new hole 5b

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Risk Of Damaging The Transmission By Mixing ATF And Transmission Fluid (MTF) Through The Same Bleeder.

The ATF and transmission fluid must be drained.

-- Draining the ATF. Refer to ATF, DRAINING AND FILLING .

-- Draining the transmission fluid. Refer to TRANSMISSION FLUID, DRAINING AND FILLING [FOR ENGINE(S) CYNB, CPNB] .

-- Secure the :3368 with the :10-222A/12 on the transmission housing as shown.

Courtesy of AUDI OF AMERICA, LLC

-- Secure the :T40155 on the :10-222A/12 and on the left flange shaft -arrow-.

-- Lift the transmission with the :VAS6100 and secure on the :T40206 as shown.