Transmission Control Module -J217-, Removing And Installing: Installing: Notes

WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.

Install In The Reverse Order Of Removal While Noting The Following:

NOTE:

Before Installing Clean The Control Module Threaded Holes Of Oil And Debris.

-- Push the control module evenly on the valve body and tighten the bolts in the sequence -1 to 4- to the tightening specification.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

A Protector Is Located On The ATF Pump.

Courtesy of AUDI OF AMERICA, LLC

Pay attention to the correct assembly.

-- Push in the sensor arm -1- on the ATF pump -2- by hand and tighten the bolts -arrows- hand-tight.

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

There Is A Risk Of Damaging The ATF Pump.

The sensor arm -1- must make contact when attaching the ATF pump -2-.

-- Tighten the bolts to the specification in the following sequence: -1 through 3-.

Fig 1: Sensor Arm Bolts Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Install the cover -1- for the sensor arm -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Install the Hydraulic Pressure Sensor 1 -G545- and Hydraulic Pressure Sensor 2 -G546-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Do Not Switch The Connectors,

Make sure that the connection is correct as shown -1 and 2-.

Refer to Hydraulic Pressure Sensor 1 -G545- AND Hydraulic Pressure Sensor 2 -G546-, REMOVING AND INSTALLING .

-- Install the Mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .