Input Shaft Seal, Replacing, 0BD: Notes
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- The flange/driveshaft used before must be installed.
- If the flange/driveshaft is also being replaced, do the following. Refer to FLANGE SHAFT RING, REPLACING, 0BD .
Special tools and workshop equipment required
- Puller - Multiple Use VW391
- Slide Hammer Set VW771
- Slide Hammer Set - Hook VW771/37
- Seal Installer - Driveshaft Flange T40112
- Retainer - Drive Flange 3028
- Seal Installer - Wheel Bearing Seal 3143
- Holding Fixture - Gearbox Adapter T10235
- Friction Gauge VAS6222
- Inductive Heater VAS6414
- Sealing Grease G 052 128 A1
- Locking Fluid AMV 185 101 A1
- Three M8 x 25 bolts
- Two M10 x 40 bolts