Flange Input Shaft Ring, Replacing, 0BD
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- The ring can only be replaced with the input shaft removed.
Special tools and workshop equipment required
- Press Plate VW402
- Press Piece - Rod VW407
- Press Piece - Multiple Use VW412
- Bearing Installer - Multiple Use 40 - 20
- Separating tool 22 to 75 mm, such as 17/1
- Input shaft removed. Refer to INPUT SHAFT SEAL, REPLACING, 0BD .
A -
Separating Tool - 22-115mm, such as Puller - Kukko Quick Action Separating Tool - 22-115mm 17/2
- Protective ring -A- installation position: the protective ring notch points upward to the Bearing Installer - Multiple Use 40 - 20.