Driveshaft, Removing And Installing From Rear Final Drive: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clamping Sleeves

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the exhaust system at the clamping sleeves -1 and 2-.

-- Tie the front exhaust pipe(s) to the underbody.

NOTE:

Do not bend the flex joint in the front exhaust pipe more than 10° or it will be damaged. Tie up the front exhaust pipes on the body and to the side.

A second technician is needed to help remove the rear section of the exhaust system.

-- Remove the rear section of the exhaust system. Refer to EXHAUST PIPES/MUFFLERS, SEPARATING .

-- Check whether there is a color marking on the driveshaft and at flange/driveshaft on the rear final drive -arrow A and arrow B-.

Fig 2: Marking Position Of Driveshaft Flange To Rear Final Drive

Courtesy of AUDI OF AMERICA, LLC

-- If one of these markings is no longer visible (for example -arrow A- on the driveshaft), then make a mark for the missing colored dot in color.

The mark on the driveshaft -arrow A- and on the rear final drive -arrow B- are on one line.

-- Remove the bolts -1- (quantity: 6) from the rear CV joint.

Fig 3: Removing/Installing Driveshaft Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Counterhold with Counterhold - Kit - Multiple Use T10172 and Counterhold - Kit - Adapter 5 T10172/5 or Counterhold - Kit - Adapter 6 T10172/6.

-- Remove the driveshaft from the rear final drive and move it to the side of the subframe.