Driveshaft On Transmission, Removing And Installing, Driveshaft Bolted On Transmission Side: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Note the instructions. Refer to OVERVIEW - DRIVESHAFT, BOLTS ON TRANSMISSION SIDE .
A two-column workshop hoist should be used when working on the driveshaft.

NOTE:

Do not bend the flex joint in the front exhaust pipe more than 10° or it will be damaged.

Fig 1: Clamping Sleeves

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the clamping sleeves -1 and 2- and disconnect the exhaust system.

-- Tie the front exhaust pipe(s) to the underbody.

-- Remove the heat shield -A- from the transmission -arrows-, if applicable.

Fig 2: Identifying Driveshaft Heat Shield

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts for attaching the driveshaft to the transmission by counterholding with the Counterhold - Multiple Use T10172A and with the Counterhold - Kit - Adapter 5 T10172/5.

Fig 3: Counterholding Driveshaft Using T10172 And T10172/5

Courtesy of AUDI OF AMERICA, LLC

-- Secure the driveshaft to the underbody.