Flywheel, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2018 Audi S6, 2017 Audi S6, 2016 Audi S6, 2016 Audi S4, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying T40176, Torque Converter -A-, And Nut -B-

Courtesy of AUDI OF AMERICA, LLC

Secure the transmission on the Engine And Transmission Holder VAS6095. Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .

-- Remove the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .

-- Attach the Puller - Clutch Module T40176 to the flywheel -A- with the nut -B- -arrow-.

-- Turn the Puller - Clutch Module T40176 upward.

Fig 2: Removing/Installing Flywheel Components

Courtesy of AUDI OF AMERICA, LLC

NOTE:

To prevent the flywheel from tilting, counterhold it underneath as illustrated.

-- Remove the flywheel from the input shaft -arrow-. Do not tilt the flywheel when doing this.