Seating area cover and upholstery, removing and installing (standard seat): Notes
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Cover
- Removal:
- Remove seat: Vehicles until 10.04 → Front seats (standard seat), removing and installing , vehicles from 11.04 → Front seats (standard seat), removing and installing .
- Remove backrest: Vehicles until 10.04 → Front backrest (standard seat), removing and installing , vehicles from 11.04 → Front backrest (standard seat), removing and installing .
- Unclip connector for heated seat - 2 - from bracket.
- Pry out plastic strips - 3 - all around using a screwdriver.
- Install cover - 1 -.
- Pry out grip channels - 4 - from plastic clips - 5 - using a screwdriver.
- Remove cover - 1 - upward.
- Remove upholstery - 6 -.
- Installing:
Installation is reverse of removal. Observe the following when doing so:
- Damaged plastic clamps - 5 - must be replaced.
- For vehicles with LATCH "Lower Anchor and Tethers for Children" bracket and new cover - 1 -, cover must be cut in at LATCH "Lower Anchor and Tethers for Children" bracket.
2 - Seat heating connector
3 - Plastic strips all around
4 - Fastening strips
5 - Plastic clips
- Replace damaged plastic clips
6 - Upholstery
7 - Seat heating
8 - Seat pan