Backrest heating element (glued in), removing and installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Removing:

Remove seat: Vehicles until 10.04 → Front seats (standard seat), removing and installing , vehicles from 11.04 → Front seats (standard seat), removing and installing .
Remove backrest part → Backrest cover and padding, removing and installing .

Fig 1: Identifying Heating Element, Electrical Wire & Gap

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Cut wire - 3 - off of old heating element - 1 -.

Installing:

Align heating element - 1 - on backrest surface, remove protective foil and glue heating element to cushion.
Insert electrical wire - 3 - into gap - 4 -.
Lay wire connections without crossing into bottom of openings at positions - 2 -.