Front power seats with memory, removing and installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Identifying Torque Wrench V.A.G. 1332

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Torque wrench V.A.G 1332

NOTE:

Before disconnecting battery: Obtain radio code.

Fig 2: Front Power Seats With Memory Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Front seat

Removal:

Remove front seat rail covers → Front seat rail covers, removing and installing .
Remove rear seat rail covers → Rear seat rail covers, removing and installing .
Push front seat - 1 - fully upward and to the rear.
Remove front bolts - 2 - (2x).

Move seat forward.
Remove rear bolts - 2 - (2x).

CAUTION: Before removing seat: Disconnect battery ground (GND) strap →

27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
27 - BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT - GENERAL INFORMATION

Tip front seat - 1 - back.
Disconnect harness connectors → Disconnecting connections .
Connect airbag adapter → Airbag Adapter VAS 6036, connecting .

Installing:

Installation is reverse of removal.

2 - Screws (4x)

Tightening torque 50 Nm