Disconnecting connections
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Technician must be grounded before disconnecting ignition and ground wiring, touching door striker or body.
1 - Front seat
2 - Belt buckle sensor connector (black)
3 - Seat heating connector (green)
4 - Current supply connector (red)
5 - Airbag connector (yellow)
6 - Connector point cover
- Removal:
- Tip front seat - 1 - back.
- Remove coupling station cover - 6 - upward.
- Press in tab on airbag connector - 5 - on tunnel side and disconnect airbag connector - 5 -.
- Connect airbag adapter → Airbag Adapter VAS 6036, connecting .
- Press in tab on connector for voltage supply - 4 - on tunnel side and disconnect connector for voltage supply - 4 -.
- Press in tab on airbag connector for heated seat - 3 - on tunnel side and disconnect connector for heated seat - 3 -.
For vehicles with seatbelt fasten sensor:
- Press in tab on connector for seatbelt fasten sensor - 2 - on tunnel side and disconnect connector for seatbelt fasten sensor - 2 -.
- Installing:
Installation is reverse of removal.