LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> S5 4.2, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1498 (Body Interior - Except Cabriolet (72-Seat-Frames & 74-Seats-Upholstery, Covers)) >> 72 - Seat - Frames >> Front Recaro seats, vehicles from 11.04 >> Rear retaining bracket, removing and installing

Rear retaining bracket, removing and installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Removing 

CAUTION: Observe safety precautions for work on airbags → Airbag safety precautions .
Fig 1: Rear Retaining Bracket Remove/Install Components
GW00021005Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing 

Installation is reverse of removal. Observe the following when doing so:

CAUTION:
  • Observe safety precautions for work on airbags → Airbag safety precautions .
  • Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "electrostatically discharge". This can be done by touching door striker, for example.
NOTE:
  • Ensure that electrical connections are pushed in as far as stop and engage with a click.
CAUTION: Ignition must be on when connecting battery. If pyrotechnic components (e.g. airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.
scientia non olet · About LEMON Manuals