Hand wheel for backrest adjustment, removing and installing
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
Removing
- Press side panel - 2 - lightly in direction of backrest.
- Slightly lift and disengage retaining detent - 1 - using a screwdriver.
- Turn hand wheel for backrest adjustment and disengage another retaining detent.
- Remove hand wheel for backrest adjustment.
Installing
Installation is reverse of removal, but note the following:
- Hand wheel must be pressed on until it audibly engages.
NOTE:
- If the hand wheel for backrest adjustment sits loosely on the adjustment shaft, the hand wheel for backrest adjustment must be replaced.