Checking Cylinder Bore (Dimensions)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2014 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Cylinder Dial Bore Gauge :VAS6078
CAUTION:
- Never handle the cylinder bore with service equipment (drilling, honing, lapping).
-- Using a :VAS6078 measure in a diagonal sequence at three positions transversely -A- and longitudinally -B-.
- Deviation from specified size: maximum 0.08 mm
| Dimension | Cylinder Bore Diameter | |
|---|---|---|
| Standard dimension | 82.51 mm | |
NOTE:
A shadow or a shiny spot on the wall of the cylinder does not mean the cylinder bore is damaged as long as the cross-lapping is still visible.
- The cylinder bore must not be measured when the cylinder block is mounted on the :VAS6095A because the measurements may be incorrect.