Tightening Specifications
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2013 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- Replace the bolts that were tightened with an additional turn after removing them.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specifications |
|---|---|---|
| 1. | -1 to 6- | Install by hand all the way |
| 2. | -1 to 6- | Aluminum bolts: 4 Nm Steel bolts: 9 Nm |
| 3. | -1 to 6- | Aluminum bolts: 45° additional turn |
TIP:
Only six bolts are installed, two bolt openings remain open.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specifications |
|---|---|---|
| 1. | -1 to 8- | Install by hand all the way |
| 2. | -1 to 8- | 9 Nm |
-- Hang the intermediate plate on the sealing flange -arrow upper- and slide it on the alignment sleeves -arrows lower-.