Coolant Pump, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2013 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Replace the seals and O-ring after removal.

-- Coat the O-rings -4- with coolant. Refer to parts information for the coolant.

Courtesy of AUDI OF AMERICA, LLC

-- Make sure that both centering pins are installed in the cylinder block if necessary insert.

-- Install the connection piece -2- into the engine oil cooler -1-.

-- Push the coolant pump -3- onto the connection piece and onto the centering pins in the cylinder block.

-- Tighten the coolant pump bolts. Refer to Figure.

Fig 1: Coolant Pump Bolt Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If a new coolant pump was installed, then the protective cap -arrow- must be removed.

-- Install the coolant pump toothed belt. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .

-- Connect the coolant hose to the connector coupling. Refer to RADIATOR/RADIATOR FAN .

There are additional procedures depending on the model. Refer to COOLANT PUMP, REMOVING AND INSTALLING .