Overview - Oil Pan/Oil Pump: Notes
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2013 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- If large quantities of metal shavings or abraded material are found in the engine oil while servicing the engine, the oil passages must be carefully cleaned to prevent subsequent damage. Replace the additional oil spray jet, engine oil cooler and oil filter.
- Oil spray jet and pressure relief valve. Refer to OVERVIEW - PISTONS AND CONNECTING ROD .
- Oil Level Thermal Sensor -G266-
- Removing and installing. Refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING
- Seal
- Always replace after removing
- Bolt
- Tightening sequence. Refer to the appropriate Service Information .
- Always replace after removing
- Oil Pan Lower Section
- Removing and installing. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING
- Oil Baffle
- Always replace after removing
- Suction Line
- Clean the screen if there are debris
- Bolt
- 9 Nm
- O-ring
- Always replace after removing
- Lubricate
- Oil Pump
- Removing and installing. Refer to OIL PUMP, REMOVING AND INSTALLING
- Centering Bracket
- O-ring
- Always replace after removing
- Oil Pressure Regulation Valve -N428-
- Removing and installing. Refer to Oil Pressure Regulation Valve -N428-, REMOVING AND INSTALLING
- Bolt
- Tightening specification -item 1- OVERVIEW - OIL PRESSURE SWITCH/OIL PRESSURE REGULATION
- Chain Tensioner
- Oil Pump Drive Chain
- Mark the running direction before removal
- Bolt
- 9 Nm
- Seal
- Always replace after removing
- Oil Separator
- On cylinder block
- Removing and installing. Refer to OIL SEPARATOR, REMOVING AND INSTALLING
- Bolt
- Tightening specification and sequence. Refer to the appropriate Service Information .
- Oil Pan Upper Section
- Removing and installing. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING
- Bolt
- Tightening specification and sequence. Refer to the appropriate Service Information .
- Always replace after removing
- Bolt
- Tightening specification and sequence. Refer to the appropriate Service Information .
- Always replace after removing
- Bolt
- 20 Nm
- Seal
- Bolt
- 9 Nm
- Seal
- Check Valve
- Oil Drain Plug
- 30 Nm
- Always replace after removing
- Nut
- 9 Nm