Input Shaft Ball Bearing, Replacing: Installing

Fig 1: Identifying Clutch Cover Components

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Replace the O-ring and locking rings. Refer to FLYWHEEL AND DUAL CLUTCH ASSEMBLY OVERVIEW .

NOTE:

The clutch cover may have or may not have a thrust washer -2-, depending on the date of manufacture.

-- If it was there during the removal, then insert a thrust washer -2- into the cover -1-.

-- Install the new dual clutch ball bearing all the way.

Fig 2: Identifying Dual Clutch Ball Bearing, Installation

Courtesy of AUDI OF AMERICA, LLC

-- Install the new ball bearing circlip -arrow-.

Fig 3: Identifying Locking Ring

Courtesy of AUDI OF AMERICA, LLC

-- Clean the sealing surface on the clutch cover.