Tire Pressure Monitoring Control Module 2 -J502-, Removing And Installing: Installing

Fig 1: Identifying Nuts And Tire Pressure Monitoring Control Module, Removal

Courtesy of AUDI OF AMERICA, LLC

Installation is the reverse of removal, with special attention to the following: 

-- If the center console was pulled out of the instrument panel when pulling the carpet back, insert the center console with the pins -1- in the instrument panel -2-.

-- Tighten the nuts -1- to 2 Nm.

-- The system must be coded again if the Tire Pressure Monitoring Control Module -J502- is replaced. Refer to TIRE PRESSURE MONITORING SYSTEM, SYSTEM DESCRIPTION  and Vehicle Diagnostic Tester.