Additional Thorax Airbag Safety Precautions

CAUTION:

We recommend using original equipment seat covers.
Seat covers or protective covers that are not specifically approved for use on Audi seats with thorax airbags must not be used.
Do not cut backrest material in thorax airbag region.
The seam in thorax airbag area must run straight when installing.
All upholstery clips must be replaced (metal and plastic clips).
We recommend using original upholstery clips.
When installing, all upholstery clips must be placed in same places as when removed.
If the cover is damaged (with rips, burned holes, etc.) in the thorax airbag area, it must be replaced for safety reasons so that airbag deploys correctly.
Do not make repairs to backrest cover in thorax airbag region (due to special materials and strictly defined seams).
The backrest padding must be replaced if the thorax airbag deploys.
All damaged parts must be replaced after a collision. If there is no damage detected on the airbag unit, the airbag unit can still be reused.
If the thorax airbag units are replaced, the new thorax airbag number sticker should be removed and placed over old sticker on the seat pan.
Do not poke cover with upholstery needle or other sharp objects in airbag and sensor mat region.