Right Flange Shaft, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Audi S4, 2015 Audi S4, 2014 Audi S4, 2013 Audi S4, and 2012 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
NOTE:
Replace the circlip on the right flange shaft.
-- Clamp the flange shaft in a vise with jaw protectors. Remove the old circlip from the groove in the flange shaft using the new circlip -A-.
-- Fill the space between the sealing- and dust lip half way with sealing grease.
-- Drive in the right flange shaft using the Bearing/Bushing Installer - Multiple Use VW295A.
-- Fill the transmission fluid (MTF). Refer to TRANSMISSION FLUID, DRAINING AND FILLING .