LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> S5 3.0T >> Repair and Diagnosis >> External Pages >> Different car >> Section 1175 (Ignition/Glow Plug System (Servicing) [CABB, CABA, CABD, CAEA, CAEB, CDHB, CDNB, CDNC, CDHA, CDZA, CADA, CCUA, CFKA, CPMA, CAED, CPMB, CHJA, CPEA] (Coupe)) >> 28 Ignition/Glow Plug System >> Ignition System >> Camshaft Position Sensor, Removing And Installing >> Removing

Camshaft Position Sensor, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2013 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Disconnect the connector -1-.

GWWA28-10115Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- and then remove the Camshaft Position Sensor -G40-.

scientia non olet · About LEMON Manuals