Dynamic Steering Overview
NOTE:
Additional information on dynamic steering can be found in Self Study Program No. 402 Audi Dynamic Steering.
- Power Steering Pump
- with an electric control valve
- The control valve is only installed on vehicles with 6- and 8-cylinder engines.
- The power steering pump and control valve are one component and are replaced together.
- Installation location in vehicles with 4 and 6-cylinder engines: On the front left of the engine (belt drive).
- Installed location on vehicles with an 8-cylinder engine: Installed on the back of the engine on the left side (chain drive).
- Actuator
- Must not be loosened or removed from the steering column.
- The actuator and steering column are one component and are replaced together.
- The system must be calibrated if the actuator is replaced. Refer to DYNAMIC STEERING BASIC SETTING .
- Removing and installing, refer to STEERING COLUMN .
- Active Steering Control Module -J792-
- The system must be calibrated if the active steering control module -J792- is replaced. Refer to DYNAMIC STEERING BASIC SETTING .
- Removing and installing, refer to Level Control System Control Module -J792- .