LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> S4 Standard Trans >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Body Panels (Hood, Lids) (Sedan) >> (55 Hood, Lids) >> Rear Lid >> Hinges, Removing And Installing >> Hinges, Removing And Installing, Sedan >> Hinge

Hinges, Removing And Installing, Sedan: Hinge

Fig 1: Identifying Rear Lid Hinge
GWWA55-10333Courtesy of AUDI OF AMERICA, LLC
  1. Door
  2. Lid Hinge
    • Removing:

      -- On the lid side, only loosen the rear nut and remove both side nuts.

      -- Unscrew the tie downs on the lower luggage compartment side trim panel.

      -- Press the luggage compartment side trim panel toward the center of the vehicle, remove the bolts for the rear shelf and remove the hinge.

    • Installing:

      -- Insert the hinge under the rear shelf and secure it lightly using the nuts.

      -- Position the lid on the hinge and secure it using the nuts.

      -- Engage the spring and the gas-filled strut.

      -- Close the lid carefully.

      -- Align the lid sideways and lengthwise.

  3. Bolt
    • 21 Nm
  4. Nut
    • 21 Nm