Tightening Specification And Sequence
WARNING: This page is about a different car, the 2010 Audi A4 and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Replaced the bolts for the ATF pan.
-- Tighten the bolts in three steps in the sequence shown:
Courtesy of AUDI OF AMERICA, LLC
| Stage |
Bolts |
Tightening Specification/Additional Turn |
| 1. |
-1 through 12- |
Install the new bolts by hand until the bolt heads touch |
| 2. |
-1 through 12- |
4 Nm |
| 3. |
-1 through 12- |
Tighten 45° further |