LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> S4 Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 88 (General, Technical Data - Automatic Transmission 0BK AWD (AVANT)) >> General, Technical Data >> Specifications >> Transmission Fluid Capacities

Transmission Fluid Capacities

WARNING: This page is about a different car, the 2012 Audi A4 and 2011 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

ATF Area in the transmission 

Capacities Automatic Transmission 0BK
Original filling by the manufacturer Approximately 8.6 liters
Filling after draining in Service 3.6 to 4.0 liters the capacity may differ depending on the engine type
Change
  • No change
  • Permanent fill; only change after repairs such as when removing the ATF pan
Lubricant For the correct ATF for automatic transmission 0BK, refer to the appropriate service information
CAUTION:

There is a risk that the transmission could malfunction or fail.

  • Use only the ATF made for the automatic transmission 0BK, which is available as a replacement part.

ATF, DRAINING OR FILLING AFTER REPAIR

Capacities Automatic transmission 0BK
Initial filling 1.0 liter
Filling after draining in Service Approximately 0.9 liters
Change
  • No change
  • Permanent fill; change only after repairs such as removing the front final drive cover
Lubricant For the correct ATF for automatic transmission 0BK, refer to the appropriate service information

GEAR OIL LEVEL IN FRONT FINAL DRIVE, CHECKING AND FILLING

Capacities Automatic transmission 0BK
Initial filling 1.0 liter
Filling after draining in Service Approximately 0.8 liters
Change
  • No change
  • Permanent fill; change only after repairs such as removing the center differential housing
Lubricant For the correct ATF for automatic transmission 0BK, refer to the approriate service information

GEAR OIL LEVEL IN TRANSFER CASE, CHECKING AND FILLING