Rear Flange Shaft Ball Bearing
WARNING: This page is about a different car, the 2010 Audi A4 and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Thrust Plate VW 401
- Thrust Plate VW 402
- Thrust Disc VW 412
- Press Tube 2040
- Tube 60 mm Dia.VW 415 A
Procedure
-- Remove the center differential housing. Refer to CENTER DIFFERENTIAL HOUSING, TRANSMISSION INSTALLED .
-- Remove the following: the locking ring from the rear flange shaft -A-, the rear flange shaft and the rear flange shaft seal. Refer to REAR FLANGE SHAFT SEAL .
-- Remove the ball bearing locking ring -B-.
NOTE:
The rear flange shaft and the seal for the rear flange shaft -A- are shown installed.
- The shoulder on the VW 415 A -arrow- faces the VW 412.