Seat rail covers, removing and installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Seat Rail Covers Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Front seat

2 - Rear seat rail covers (2x)

Removal

Drive front seat - 1 - to center position.
Remove seat → Front power seats with memory, removing and installing .
Pry out seat rail cover - 2 - from beneath or - 3 - on the inside.
Pry out seat rail cover on the outside.

Pull off seat rail cover - 2 - or - 3 - as straight as possible.

Installing

Installation is reverse of removal.

3 - Front seat rail covers (2x)