Seat height adjustment motor, removing and installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Special Tool - Engine And Transmission Holder VAS 6095

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Engine and transmission holder VAS 6095

Fig 2: Fixture For Seat Repair VAS 6136

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fixture for seat repair VAS 6136

NOTE:

If motor is defective, replace upper seat pan frame.

Fig 3: Longitudinal Seat Adjustment Motor Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Four-way lumber support motors (Qty. 2)

2 - Seat height adjustment motor

Removal

Remove seat → Front power seats with memory, removing and installing .
Mount the fixture for seat repair VAS 6136 on the engine and transmission holder VAS 6095.
Attach the front seat to the fixture for seat repair VAS 6136.
Remove side trim on sill side → Side panels on door sill side, removing and installing .

Remove side trim on tunnel side → Tunnel-side side trim, removing and installing .
Remove the backrest → Front backrest, removing and installing .
Remove cover and padding from seat pan → Cover and cushion for seat pan, removing and installing (sport seat) .
Remove control module → Control Module for memory seat, removing and installing .

Remove belt buckle → Seat belt anchor, removing and installing .
Remove spring mat with wiring harness from seat pan → Spring mat with wiring harness in seat pan, removing and installing .
Separate upper seat pan frame from lower seat pan frame.

Installing

Installation is reverse of removal.

3 - Seat angle adjustment motor

4 - Longitudinal seat adjustment motor

5 - Backrest adjustment motor