Spring mat with wiring harness in seat pan, removing and installing
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
Special tools, testers and auxiliary items required
- Engine and transmission holder VAS 6095
- Fixture for seat repair VAS 6136
1 - Cable tie
- Qty. 2
2 - Spring mat with wiring harness
- Removal:
- Remove seat → Front power seats with memory, removing and installing .
- Mount the fixture for seat repair VAS 6136 on the engine and transmission holder VAS 6095.
- Attach the front seat to the fixture for seat repair VAS 6136.
- Remove side trim on sill side → Side panels on door sill side, removing and installing .
- Remove side trim on tunnel side → Side panels on door sill side, removing and installing .
- Remove the backrest → Front backrest, removing and installing .
- Remove drawer → Drawer, removing and installing .
- Remove cover and padding from seat pan → Cover and cushion for seat pan, removing and installing (sport seat) .
- Remove cable ties - 1 - (Qty. 4)
- Disengage spring mat - 2 - at - A - positions (Qty. 2).
- Disengage spring mat - 2 - at - B - positions (Qty. 4).
- Tip seat pan to side.
- Disconnect connectors - 3 -, - 7 - and - 8 - (Qty. 3).
- Disconnect connector - 11 - (Qty. 2).
- Remove screw - 10 -.
- Remove wiring harness at clips - 4 - and - 5 - (Qty. 4).
- Remove spring mat with wiring harness - 2 -.
- Installing:
Installation is reverse of removal.
3 - Connector
4 - Clip
- Qty. 2
5 - Clip
- Qty. 2
6 - Cable harness
7 - Connector
8 - Connector
9 - Washer
10 - Screw
- 3.5 Nm
11 - Connector
- Qty. 2