Headrest with slide in locking mechanism, removing and installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pushing Release Button In And Pulling Headrest Upward As Far As Possible

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing

Push release button - 2 - in - direction of arrow A - and pull headrest - 1 - upward as far as possible - arrow B -, keep release button pushed while doing so.

Fig 2: Pressing Release Button On Headrest Until Stop

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Press release button - 2 - on headrest - 1 - until stop - arrow -.
Slide headrest down completely on rods, release button on headrest must be kept pressed while doing so.
Remove headrest completely from headrest guides.

Installing

Installation is reverse of removal.