Control module, removing and installing
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
Removing
- Push front seat fully upward and to the front.
- Remove bolts - arrows -.
- Disconnect electrical harness connectors - 1 - and - 2 - at rear of control module.
- Remove control module.
Installing
Installation is reverse of removal, noting the following:
Tightening torque
| Component | Nm |
|---|---|
| Control module to seat frame | 1.5 |