Auxiliary Components Bracket, Removing And Installing, Vehicles With Hydraulic Power Steering: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2014 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove The Ribbed Belt Tensioner. Refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING [CAEB, CAED, CPMA, CPMB] .

-- Disconnect the connectors -1 and 4- from the Oil Pressure Switch - F22- and Reduced Oil Pressure Switch - F378-.

Fig 1: Identifying Oil Pressure Switch

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 and 2- and move the front coolant pipe upward.

Fig 2: Front Coolant Pipe

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamps -arrows- and remove the air duct hose.

Fig 3: Air Intake Hose Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove The Generator. Refer to GENERATOR, REMOVING AND INSTALLING .

-- Remove The A/C Compressor From The Sub-Assembly Bracket And With The Refrigerant Hoses Connected Tie It Up To The Left Side. Refer to A/C COMPRESSOR, REMOVING AND INSTALLING / OVERVIEW - A/C COMPRESSOR POWER UNIT .

-- Remove The Power Steering Pump And With The Hydraulic Lines Attached Place On The Longitudinal Member. Refer to POWER STEERING PUMP, VEHICLES WITH DYNAMIC STEERING [CAEB, CPMA] / POWER STEERING PUMP, VEHICLES WITHOUT DYNAMIC STEERING [CAEB, CPMA] .

All additional procedures are described. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING .