Headliner, Removing And Installing (Sedan): Removing

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .

-- Adjust the front seat backrests to a 45° angle.

-- Remove the upper A-pillar trim panels. Refer to A-PILLAR TRIM PANEL, REMOVING AND INSTALLING .

-- Remove the sun visors. Refer to SUN VISOR, REMOVING AND INSTALLING .

-- Remove the sun visor center support. Refer to SUN VISOR CENTER SUPPORT, REMOVING AND INSTALLING .

-- Remove the windshield. Refer to WINDSHIELD, REMOVING AND INSTALLING .

-- Remove the roof grab handle. Refer to ROOF GRAB HANDLE, REMOVING AND INSTALLING .

Versions equipped with a sunroof:

Fig 1: Identifying Sunroof & Sun Shade

Courtesy of AUDI OF AMERICA, LLC

-- Open the sunroof -1- all the way.

-- Open the sun shade -2- about ² /₃ .

-- Clean the Trim Release Lever T10039 to avoid soiling headliner.

Fig 2: Releasing Roof Panel Clips

Courtesy of AUDI OF AMERICA, LLC

-- Let Trim Release Lever T10039 slide along between sunroof cover frame -2- and headliner -1- until it touches one of the 15 clips -3- (See Fig 2).

-- Release the clips one after consecutively using the Trim Release Lever T10039 as shown in the image -arrow-.

Continuation for all vehicles:

Fig 3: Removing Bolt -1- In Front Interior/Reading Light Roof Opening

Courtesy of AUDI OF AMERICA, LLC

-- If equipped, remove the bolt -1- in the front interior/reading light roof opening.

Fig 4: Unclip Headliner -1- At Rear From Body -Arrows

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

-- Unclip the headliner -1- at the rear from the body -arrows-.

NOTE:

Two technicians are needed to loosen the last connections and to remove the headliner.

-- Remove headliner through windshield opening.