LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> S4 Automatic DCT Trans >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Body Panels (Hood, Lids) (Sedan) >> (55 Hood, Lids) >> Rear Lid >> Hinges, Removing And Installing >> Hinges, Removing And Installing, Sedan >> Spring Engaging Points

Spring Engaging Points

Fig 1: Identifying Spring Engaging Points
GWWA55-10334Courtesy of AUDI OF AMERICA, LLC
  1. Spring
    • Engaging:

      -- With the lid closed, engage the spring first on the hinge side and then on the body side.

      -- On the left side of the vehicle, the spring eyes must face down on the retaining pins, as shown in the magnified section of the illustration.

      -- Up on the right side.

    • Body engaging points:

      -- On the right side, engage the sprint at point -a-.

      -- On the left side, engage the spring at point -d- after installing the lid hinge end stop.

  2. Retaining Pin
    • Note the different directions for engaging the spring on the left and right.
    • The spring eye faces down on the left side and up on the right side.