Hinges, Removing And Installing, AVANT

Fig 1: Removing/Installing Rear Lid Hinge (Avant)

Courtesy of AUDI OF AMERICA, LLC

1. Bolt
   • 21 Nm
2. Lid Hinge

   Removing:

   -- Remove headliner. Refer to Roof Trim Panels .

   -- Remove the rear lid hinge cover. Refer to Fig 2.

   NOTE:

   Support the rear lid to keep it from falling down and too prevent damage the rear lid or the vehicle body.

   -- Remove the bolts -3- from the lid.

   -- Remove the bolt -1- and hex nut -4- and then remove the hinge.

   Installing:

   -- Place the hinge onto the body and gently tighten the nut -4- on the roof frame.

   -- Then lightly attach the hinge on the side with the screw -1-.

   -- Secure the hinge with the screws -3-.

   -- Align the lid to the body on the left and right side and tighten the screws -3- to the tightening specification.

   -- Adjust the height of the lid to the roof and then tighten the bolt -1- and nut -4- to the tightening specification.

   -- Press on hinge cover.

3. Bolt
   • 21 Nm
4. Hex Nut
   • 21 Nm

Fig 2: Rear Lid Hinge Cover

Courtesy of AUDI OF AMERICA, LLC

-- Cover is placed on rear lid hinge.

-- Loosen side locking tabs on cover -1- and remove from hinge -2-.

-- To install, position retainer tabs in catches on hinge arm and press opposite side of cover down completely.

-- The cover must audibly engage.