LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> S4 Automatic DCT Trans >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Interior Trim (Sedan) >> 70 Interior Trim >> Passenger Compartment Trim >> Carpet, Removing And Installing >> Removing

Carpet, Removing And Installing: Removing

-- Remove the front seat:

-- Remove the bench seat. Refer to SEAT BENCH/SINGLE SEAT, REMOVING AND INSTALLING .

-- Remove the instrument panel cover on the driver side. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

-- Remove the center console. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .

-- Remove the center console bracket and lower the shift mechanism. Refer to CENTER CONSOLE BRACKET, REMOVING AND INSTALLING .

-- Remove the rear center console vent on the center tunnel. Refer to Air Conditioning .

-- Remove the front sill panel strip. Refer to SILL PANEL STRIP, REMOVING AND INSTALLING, FRONT SILL PANEL .

-- Remove the rear sill panel strip. Refer to SILL PANEL, REMOVING AND INSTALLING, REAR SILL PANEL .

-- Remove the B-pillar lower trim piece. Refer to B-PILLAR TRIM PANEL, REMOVING AND INSTALLING, LOWER B-PILLAR TRIM PANEL .

-- Disengage the floor covering at brackets -1- and -2-.

Fig 1: Disengaging Floor Covering At Brackets -1- And -2
GWWA70-10660Courtesy of AUDI OF AMERICA, LLC

-- Pull the floor covering -3- back.

NOTE:

Make sure the floor covering does not tear at the openings.

-- Fold the floor covering lengthwise and remove it through a door.