Upper Rear Lid Trim Panel, Removing And Installing: Installing

Fig 1: Identifying Spring Clamps And Rubber Buffers

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

NOTE:

If the trim panel clamps -2- remain in the rear lid mounting points, remove them with the Omega Clip Tool T40280 and insert them in the trim when installing.

Check clamps for damage or deformation, replace if necessary.

-- Make sure all the rubber buffers -1- are in the trim.

-- Insert the trim panel first behind the side window frame in the rear lid.

-- First clip the rear lid trim panel at the top and then down the sides.