General Information And Components
The high beam assistant makes it possible for the high beams to switch on and off based on the traffic and the ambient conditions. This prevents glare for the other motorists as well as unnecessary use of the high beams.
This function is possible only if the vehicle has a rain/light recognition sensor and an automatic high beam control module.
The automatic high beam switch-on includes the following components:
- Headlamp Switch -E1-
- Turn Signal Switch -E2-
- Rain/Light Recognition Sensor -G397-
- Instrument Cluster Control Module -J285-
- Vehicle Electrical System Control Module -J519-
- Steering Column Electronic Systems Control Module -J527-
- Data Bus On Board Diagnostic Interface -J533-
- Automatic High Beam Control Module -J844 - with a camera with CMOS images sensors
- Left High Beam Headlamp -M30- and Right High Beam Headlamp -M32- (Halogen)
- Left Low Beam Reflector Motor -V294- and Right Low Beam Reflector Motor -V295- (Bi-Xenon)