Axle Oil Level In Front Final Drive, Checking
Special tools and workshop equipment required
- Used Oil Collection and Extraction Unit VAG 1782
NOTE:
General Repair Instructions. Refer to GENERAL REPAIR INFORMATION .
When checking oil level, vehicle must be on a level surface.
Procedure
-- Remove the bolts and remove front noise insulation -1-.
-- Move the Used Oil Collection and Extraction Unit VAG 1782under the front final drive.
-- Remove the plug for checking the transmission fluid level -arrow-.
- Specified value: Oil level up to bottom edge of oil filler hole.
-- Fill the gear oil if necessary. .
-- Install the plug -arrow- with a new gasket.
- Tightening specification SHAFT SEALS, REAR FINAL DRIVE 0BN AND 0BP OVERVIEW.