Seal For Flange/Driveshaft On Front Final Drive, Replacing (Final Drive Removed): Removing

-- Remove the front final drive. Refer to FRONT FINAL DRIVE, REMOVING AND INSTALLING .

-- Remove the O-ring -1- and the locking ring -2-.

Fig 1: Identifying Seal -1- And Locking Ring -2-

Courtesy of AUDI OF AMERICA, LLC

-- To install the screws -arrows- into the dust cap, first use a needle bearing drift to punch two holes in the dust cap.

Fig 2: Identifying Removal Of Dust Cap Using Puller T10055 And Adapter T10055/2

Courtesy of AUDI OF AMERICA, LLC

-- Install the 4 mm diameter screws.

-- Remove dust cap using the Puller - Unit InjectorT10055.

-- Punch two holes in the shaft seal using a needle bearing drift.

-- Install the 4 mm diameter screws.

Fig 3: Identifying Installation Of 4mm Screws

Courtesy of AUDI OF AMERICA, LLC

-- Remove the shaft seal using the Puller - Unit InjectorT10055.