Right Flange Shaft Dust Cap, Replacing

Special tools and workshop equipment required

Procedure

Fig 1: Pressing Off Dust Cap From Flange Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Remove the dust cap -B- from the flange shaft.

A -

Separating ToolKukko 17-2

-- Install the new flange shaft dust cap -A- using the Thrust Piece3456 and Subframe Bushing Tool Kit - Assembly Tool 33301/3.

Fig 2: Identifying Installation Of Flange Shaft Dust Cap -A- Using Press Piece 3456 And Assembly Tool 3301/3

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Mount the Subframe Bushing Tool Kit - Assembly Tool 33301/3 so that the recess faces the dust cap -A-.