Front Driveshaft, Removing And Installing: Installing

Fig 1: Identifying Seal -1- And Locking Ring -2-

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

• Tightening specifications. Refer to FRONT DRIVESHAFT OVERVIEW .

-- Install a new O-ring -1- and new locking ring -2-.

-- Attach the Driveshaft to the front final drive.

Fig 2: Identifying Installed Position Marks

Courtesy of AUDI OF AMERICA, LLC

• The markings on the Driveshaft and the final drive -arrow- must line up.

-- Install the Drive Axle on to the flange with a quick push being careful not to angle it. If it does not slide onto the flange, use a piece of wood -A-. Pull the Drive Axle to make sure it secure.

Fig 3: Identifying Installation Of Driveshaft

Courtesy of AUDI OF AMERICA, LLC

-- Attach the Driveshaft to the transfer case with new bolts -arrows-.

Fig 4: Identifying Driveshaft Bolts -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Use the Counterhold - Kit - Multiple UseT10172 and adapters T10172/6.

-- Install the transmission carrier. Refer to TRANSMISSION CARRIER AND CONSOLE, REMOVING AND INSTALLING .