Bonded Rubber Bushing In Front Housing, Removing And Installing: Installing

Fig 1: Identifying Vertical Alignment Of Small Hole And Large Recesses -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Mount the bonded rubber bushing on the final drive in its installed position.

NOTE:

The small hole -A- and the larger recesses on the bonded rubber bushing -arrows- must be vertical to the final drive.

-- Install the bonded rubber bushing until it is fits into the center of the front final drive housing.

Fig 2: Identifying Tool Assembly To Install Bonded Rubber Bushing

Courtesy of AUDI OF AMERICA, LLC