Vehicle Diagnostic Tester, CONNECTING AND SELECTING FUNCTIONS
Special tools and workshop equipment required
- Vehicle Diagnostic Tester with corresponding diagnostic cable.
- During a test drive, the testing and measuring equipment must always be secured on the back seat.
- These devices may be operated only by a passenger during a test drive.
-- Connect Vehicle Diagnostic Tester with corresponding diagnostic cable to vehicle.
-- Switch Vehicle Diagnostic Tester on.
Vehicle Diagnostic Tester is ready to operate when it displays operating modes in button fields.
-- Turn on the ignition.
If control modules or electric/electronic components were replaced, component adaptation should generally be carried out in "Guided Fault Finding".
-- Touch Guided Fault Finding .
-- Select in succession:
- Brand
- Type
- Model year
- Version
- Engine Code
-- Confirm data entered.
Wait until tester has checked all control modules in vehicle.
-- Press the go to button and select "function/component selection".
Then
-- "Chassis (Repair group 01; 40 - 49)".
-- "34 - Level control (Repair group 01: 43, 44)".
-- "01- On Board Diagnostic (OBD) capable systems".
-- "34 - Level control system control module ".
-- "J197 - Level control system control module functions".
or
-- "Chassis (Repair group 01; 40 - 49)".
-- "34 - Level control (Repair group 01: 43, 44)"
-- "01- On Board Diagnostic (OBD) capable systems".
-- "34 - Level control system control module ".
-- "Electrical components".