Drive Plate With Cylindrical Roller Bearing

-- Remove drive plate from compressor shaft, refer to DRIVE PLATE .

-- Remove circlip -A-.

Fig 1: Identifying Securing Ring, Drive Plate & Bevelled Side

Courtesy of AUDI OF AMERICA, LLC

-- Remove drive plate -B-.

NOTE:

Replace circlip -A-.

Clean compressor flange before sliding on drive plate.

When installing the circlip -A-, note that it cannot be bent open more than is necessary for installation.

Insert circlip -A- on proper side, the side with beveled insertion edge -C- faces away from compressor (install flat side facing compressor).